Accton-technology SIP Gateway VG3300 Series Manual do Utilizador descarregar pdf (Página 19)

Mapping table of characters used in PPPoE.

Example user name：[email protected]，Password：123ab，The procedure is below

1. Connect the phone to the gateway

2. When CPU/ACT is light, pick up the phone and press

3. ##0000

；You will hear 3 short tones.

4. 0938333732314068696*465742*46*46574#

；Set user name：[email protected]

5. 103132336162#

；Set password is 123ab

6. 981#

；Save and restart.

2. Use Console to configure (Only VG3306/3310/3318)

SIP-RG>enable

SIP-RG#configure

Enter configuration commands, one per line. End with CNTL/Z

SIP-RG(config)#pppoe username [email protected]

SIP-RG(config)#pppoe password 123ab

SIP-RG(config)#exit

SIP-RG#restart

This command resets the system. System will restart operation code agent.

Reset system, [Y]es or [N]o? Yes

3. Use WEB Interface to configure:

You can configure the user name and password by using WEB interface. Follow the steps to finish

configuration.

Step 1: Using a traditional phone set to configure the web management password and phone

number

You will need to use a web browser to perform the PPPoE settings through the gateway’s web

based management interface. To enter the web based management interface you must have a

previously configured password. Follow the next procedure to setup your password and phone

number.

1. Connect the gateway to a suitable Power source.

2. Connect a traditional phone set to the “Phone” connector located on the rear panel.

3. When the CPU/ACT light is on, pick up the phone. You should hear the dialing tone.

4. ##0000 ; you should hear three short tones.

15123 ; “123” is the web management password.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 84 85

Sem comentários

Accton-technology SIP Gateway VG3300 Series Manual do Utilizador Página 19